Stand under your own heat

Stand for hot, made by own hands, can become an original decoration of the kitchen or an unusual gift for a good housewife. Let's consider three interesting variants how to make a stand under hot from various materials.

Stand for hot from felt

1. We make the first stand in the form of a citrus circle. For one stand under the hot from felt we cut 11 parts: two color circles, one white circle a little smaller and eight triangles-sectors. In some triangles we cut small holes.
2. We put a white circle on one colored circle and arrange triangles. We fasten all the sewing pins and begin sewing details with a simple seam "forward needle".
3. When the front is ready, we connect it with the remaining color circle with the same seam. At the edges cut off the excess protruding felt.
4. Stand ready! Now you can sew a company in the form of circles of lemons, oranges, grapefruits. Such supports on the table under the hot, not only save furniture, but also raise the mood.

Stand for hotter disks and fabrics

1. Two disks will serve as the basis for delivery. You will also need fabric and sintepon (it is more convenient to work if it is quilted). Cut out two circles of fabric and two of the sintepon, so that each 2cm protrudes beyond the edge of the disc.
2. We lay out a circle of fabric and inside a circle of synthepone, we make a marking along the edge with a thread, and we tighten it.
3. The same is done with the second disk, the base of the product is ready. Before sewing the stand under the hot of these two parts, you need to prepare a side edging. We take a cord of the length that corresponds to the length of the circumference of the disc, we take the tape, the oblique bake or strip of fabric and we sew the cord.
4. It remains to sew to the cord from both sides of the discs.
5. From the discs of the stand under the hot are practical due to the strength and they are easy to make, because the base is already ready.

Stand for hot tiles in decoupage technique

1. You will need squares of ceramic tiles, felt and napkins, as well as glue and varnish.
2. To begin with, the tiles are cleaned and degreased, then we apply a glue for decoupage on one side to the surface and glue the napkin (this can be ordinary printed paper with a pattern).
3. When the stand dries, the top is also covered with glue. After 15 minutes, we apply another layer - in total we apply 4 layers of glue from the top and at the end we cover everything with varnish.
4. When the front side is completely ready, on the back side we glue the felt, so that the holders under the hot technique in the decoupage technique do not damage the surface of the table.

Do not do in the kitchen and without potholders , which can also be done with their own hands.