An alternative to live flowers is the use of flowers when composing flowers from a variety of fabrics that do not fade and remain beautiful and bright for a long time.
In this article, you will learn how to make bouquets of ribbons.
Master class on making a bouquet of ribbons
It will take:
For one rose:
- satin ribbon 3 cm wide and 65 cm long;
- scissors, ruler, stapler.
For a bouquet:
- a ball of foam 10 cm in diameter, cut in half;
- a round wooden handle with a diameter of 2-3 cm and a length of 15-20 cm;
- cone for a bouquet;
- white satin ribbon 4 cm wide;
- 20 - 25 folded from ribbons of roses;
- glue gun;
- A narrow ribbon and rhinestones for decoration.
We make a rose:
- Cut the end of the tape at an angle of 45 °.
- We put the tape on the table and, having retreated from its edge 5 cm, we fold it at an angle of 90 ° downwards.
- Stepping back 5 cm, turn the tape two more times 90 °, so that a square with a small hole in the center turned out of it.
- Repeat the folding of the tape until it ends. We make sure that the hole remains.
- Clamp the folded tape with two fingers, the horses with a bevelled edge gently thrust into the hole in the center.
- While holding the layers, stretch the tape back in front until it creates a rose.
- While holding the bud, gently twist the top layer to form the center of the rose. If necessary, twist more tightly and the second layer.
- The ends of the tape tightly twist and fasten close to the flower stapler. Superfluous pruning.
- Using steps 1-8, from different tapes we make several such roses of different colors.
Assembling a bouquet:
- Cut in the foam plastic groove depth of 1-1.5 cm and width as a wooden handle.
- We glue the handle to the foam plastic glue gun.
- The base of the cone is expanded to the size of the handle.
- On the upper side of the circumference, we apply a hot glue, insert the pen with foam and press it so it sticks.
- It should look like the picture.
- The bottom of the handle is sealed with a piece of white tape.
- From below, the base of the cone is pasted with a white tape, making wrinkles.
- Then close the entire handle in a spiral.
- Starting from the top of the hemisphere, we glue the roses from the ribbons so that the base is not visible.
- The handle is decorated with rhinestones and other elements.
- Our bouquet of ribbons is ready!
Made by hand from satin ribbons, flowers, collected in beautiful bouquets, you can use as wedding, and for decorating other holidays.
For bouquets, you can make other variations of colors from satin ribbons .
