The decoration of the slopes of plastic windows is an important time for installing the entire structure. A qualitatively performed similar work creates a tightness in the room and protects the window from the appearance of cracks and drafts.
Run it easily on your own using different materials. There are several options for finishing the slopes of windows, for this, plasterboard, plaster, plastic can be used. Plastic panels are easy to install, easy to clean and unpretentious in care. They are considered to be the most practical and durable material.
Such a design is ideal for a plastic window, composes a single composition with it on the inside of the room. If desired, under the plastic slope is additionally installed a heater, for example, a layer of mineral wool.
Finishing slopes of windows inside
To finish the internal slopes of plastic windows will need:
- plastic panel;
- starting line;
- F-shaped profile;
- angular profile;
- self-tapping screws;
- drill;
- plastic bushings;
- screwdriver;
- nippers;
- roulette;
- level.
- Initially, the window opening is leveled. For this, a metal corner is used. The slope is measured. The starting strip for it is cut off with the help of wire cutters.
- The starting strip is fastened as accurately as possible to the profile of the window along the perimeter with self-tapping screws. It will play the role of the base for the plastic panel.
- Into the corners is inserted an angular profile.
- The plastic sleeves are blocked into the wall after a certain distance.
- In these holes with the help of self-tapping screws and screwdriver mounted F-shaped profile, which is the transition from the slope to the wall and cashing in for the opening. The main thing is to cut it exactly at an angle in the intersection to create a beautiful joint. Cut the clypeus can be directly on the wall after the laths are installed overlapping each other.
- Then the plastic panel is trimmed along the length and inserted into the base - the starting bar and cashing. The finish of the slope can be considered complete.
Finishing of slopes of plastic windows outside
The decoration of the slopes from the outside also has an important aesthetic and practical significance. It can be done with plaster.
For work on the design of an external slope you will need:
- plaster on the basis of cement and gypsum;
- putty knife;
- paint;
- mounting foam and gun;
- putty finish;
- mesh for grouting and holder;
- primer;
- brushes.
- After installation outside the window, there are gaps and pieces of foam.
- The slots are additionally sealed with foam.
- Remains of dried foam are cut with a knife.
- A solution of plaster is prepared. The slope is plastered with a spatula. The foam should be well closed with a solution to prevent it from breaking down over time.
- After the lower part of the slope is plastered, the tide turns.
- Then the lateral and upper part of the slope is plastered.
- To create a smoother surface, the slope is covered with a layer of finish putty.
- After drying, putty, which is withered on the frame, is carefully removed with a spatula.
- With the help of a special mesh and holder, putty is ground for painting.
- The slope is covered with a primer for better adhesion of the surface to the paint.
- The slope is painted with acrylic paint for outdoor work. Finishing finished.
Finishing the slopes of plastic windows does not take much time. You can deal with it yourself without the help of specialists. Such a lining allows you to complete the creation of an aesthetic interior inside and outside.
