Stove-fireplace with own hands

The construction of a stove-fireplace by one's own hands is not too simple, in which there are certain nuances. However, if you carefully study the technical side of the question and choose suitable materials, it will be realistic to implement the project.

Fireplace-oven for home with own hands

Installation of the stove-fireplace with their own hands is performed only with the use of a special refractory brick and solutions suitable for the construction of heating elements. Our furnace will have a conventional furnace, as well as a fireplace fireplace from a finished cassette, but there will not be a hob in the oven.

1. Construction begins with the installation of the base of the furnace. It should be located below the floor level, at least three times the width of the masonry. The foundation is reinforced with metal piles and reinforcing mesh.
2. On the foundation, three rows of masonry should be raised. This must be done in such a way as to completely level the base of the future furnace.
3. On the finished base, the shape of the future furnace is laid out. It has three compartments: for a fireplace, for a firebox, and also for a drovnitsa. Still need to leave holes for the bluff.
4. We raise the walls of the stove to the height necessary to establish the finished cassette of the fireplace. Carefully install the cassette.
5. We raise the masonry in such a way as to close the fireplace cassette. Together with this, we spread the furnace and the podduvala, as well as the drovnitsu. The metal parts in them will be installed at the very end.
6. The upper part of the fireplace is also covered with a brick cut off according to the shape we need.
7. We lay out the walls of the oven, combined with the fireplace, with our own hands above the level of the fireplace fireplace and unite the chimneys.
8. The upper part of the furnace is thoroughly smeared with cement mortar, so that the smoke does not leave any other openings.

Withdrawal of chimney

1. The next stage of how to build a stove-fireplace with your own hands is to remove the chimney and build a pipe. For starters, a firewall bricks should be laid out.
2. Next, cut the ceiling in accordance with safety requirements (the opening should be at least 75 cm). At the same time, you can not stand on the lined stove. The opening is cut from the attic. There goes up a brick to build a pipe.
3. The chimney is laid out around the resulting hole in the oven and rises through the slit in the ceiling to the attic. The outlet is coated with basalt wool.
4. Then the chimney goes to the attic. In this case, a small door should be installed here for the convenience of cleaning the pipe. The exit point through the roof should also be covered with basalt wool.
5. After this, lay the pipe on the roof.
6. Now you need to install all the metal elements in the oven. Now it is ready for finishing with decorative tiles or bricks.