Few will refuse to actually a bathhouse, where it is possible to spend time with pleasure and pleasure with family and friends. Very popular today is the independent construction and decoration of the bath, as well as the manufacture of furniture for it. To do this, you need to make some effort and invest, as well as stock up some knowledge.
Interior finishing of a bath from a bar
Baths from a beam are very popular thanks to a cozy interior and exterior, natural materials and maximum benefit for the body. In this case, to organize the right pair, you need to take care of the quality thermal insulation of the steam room. Despite the lower thermal conductivity of the timber compared to the brick, it is still very good to insulate it.
Thermal insulation of the bath will be the first stage of its finishing, after which the finishing stage will be finished - a clean lining of the internal walls. Begin to insulate the bath of glued beams can be immediately after installation. If it is a frame, then no sooner than six months later, so that the construction will give the final shrinkage and no longer threatened with deformation.
Interior decoration of the bath, and in particular - its insulation, can be made using natural and synthetic materials. Natural materials undergo additional treatment with impregnations to protect them from pests and fungus, but this is not safe for health.
If you prefer natural materials, then it is better to choose untreated lnozhut felt or lnovatin - they last longer against decay and do not harm health during the operation of the bath.
As for synthetic materials, polystyrene and mineral wool have proved to be the best. They are safe and have a low thermal conductivity, because they are great for warming timber saunas.
The best material for a finishing (finishing) interior finish of a bath is a wooden lining. It is preferable to choose planks of lime and other deciduous trees, as coniferous rocks, when heated, emit a lot of tar and burn the body.
Internal finishing of a brick bath
Brick sauna has its advantages and disadvantages in front of the wooden. Among the positive moments - greater fire safety, reliability and durability. A disadvantage is slow heating and rapid cooling.
To get rid of such high thermal conductivity, you need to take care of the quality of the thermal insulation of the bath, especially the steam room. Thermal insulation of a brick bath should begin with the thermal insulation of the floor and the installation of wooden floors, preferably with electric heating.
Then you need to waterproof and insulate the walls, vapor-proof with foil or foil fabric, after which you can proceed to the inner skin. And already at the very end of the ceiling.
Among the common types of interior decoration of the bath are hardwood decking. The highest resistance to moisture is characterized by alder, linden and aspen. Quality wooden lining has a smooth surface with special grooves, which guarantee a tight fit. On top of the lining in any case can not be treated with varnishes and antiseptics.
Interior design of the bath
In the bathhouse, as in a place of rest, everything should be as cozy, calm, peaceful, without bright accents and unnecessary accessories. In advance, think out the color scheme, and if you want to make some modern elements (chrome faucets or ceramic tiles), then try to write them in the most harmonious and natural way.
It is important to think over the lighting - it must be warm shades to emphasize the intimacy and calm of the atmosphere. You can dim the light with a lampshade or a filter. It is mandatory that all electrical fittings should be moisture resistant, and all wiring elements are reliably protected from moisture.
It is desirable to make furniture for a bath round, without sharp corners and bulging details. Of course, all of it must also be wooden - made of alder, linden, aspen, etc.
| | | |
| | | |
| | | |
