How beautifully to paste wallpaper? Finishing requires attention and compliance with the rules. Consider the total area of the walls (ceiling), the length and width of the roll, a small percentage should be provided for surplus.
Check the identity of the product numbers and product series. Unpack the rolls and fan them, the color should match. The structure is checked by joining the ends. Working with conventional wallpaper is more difficult compared to how to paste "monolithic" liquid wallpaper.
How to paste wallpaper on the ceiling?
The algorithm of how to paste wallpapers on walls is similar to how they are applied to the ceiling.
- The surface must be prepared. You can remove the wallpaper with a roller-hedgehog or a wallpaper "tiger".
After perforation, apply a small amount of water or a special solution and leave to soak for 10 minutes. The old layer is easily removed.
Spill and coat the ceiling.
- Dilute the glue in the correct proportion with water. Apply the mixture to the fabric (except non-woven wallpaper), roll up, give time for impregnation.
- Marking is done. On the ceiling the strips go in the direction of the light in order to hide the unevenness of the corners as much as possible. The first element is not from the corner, but distant from the wall. For example, the wallpaper has a width of 53 cm, the mark should be at a distance of 50 cm.
A powder staining the cord is poured into the cassette of the marking cord. Markup is done in 2 accounts.
- Attach the cloth, press firmly, walk on the surface with a platen. Remove excess with spatula and knife-cutter.
- How to paste wallpaper in the corners? The joint should not fall on the corner, eventually it will "disperse", so you need an overlap. With an external corner, it is convenient to make a cut along the diagonal, continue to paste.
- If there are holes in the ceiling, seal them with wallpaper, then cut out the excess. Walk the roller.
How to paste wallpaper of two kinds and pasted an arch?
A difficult place is the arch . Here are 2 ways to design:
- At the junction point, there should be an overlap of 2-3 cm. It is repeatedly cut and folded, glued to the vault. The finished strip is glued to the vault.
- You can also use the finished plastic corner, previously cut. He is put on glue, shpaklyuyut, polished, glue wallpaper on top.
How to paste wallpaper with a picture will prompt the manufacturer. The packaging specifies the method of joining. Before you paste wallpaper two or more colors in several levels, make a markup.
- The first is attached the upper, lower, then the middle cloth.
- The middle part goes down by 1 cm.
- Make a cut and delete the excess.
Got:
